What is extended PRF?

By Puredent Team Published October 8, 202610 min read
Short answer

Extended PRF (e-PRF) is a form of platelet-rich fibrin (PRF) in which the platelet-poor plasma layer (PPP) is heated so that the albumin forms a gel. The gel is then mixed with the PRF fraction. The scientific term is Alb-PRF. The result is an autologous biomaterial that degrades more slowly than regular PRF and can be used, among other things, as a biological barrier membrane.

What is extended PRF?

Regular PRF is prepared from the patient's own blood without anticoagulants and forms a fibrin clot with platelets and leukocytes. The disadvantage is that PRF degrades quickly in the tissue. A systematic review of 75 studies published by Farshidfar et al. in Periodontology 2000 indicates a degradation time of 2-3 weeks for regular PRF and describes how PRF membranes that last around 4 months can be made by denaturing the albumin in the plasma.1 If you are new to PRF, you can read about the basic concepts in What is PRF?

What is it called?

The same principle goes by several names. Alb-PRF is often used in scientific articles. e-PRF (extended PRF) is the working name Estrin et al. use for their technique.2 The names do not necessarily refer to completely identical preparations, because centrifugation, heating, and mixing vary between the studies.

Why does it last longer?

During centrifugation, the blood separates into layers in the tube. At the top is the PPP, which contains a lot of albumin. When it is heated, the albumin denatures and solidifies into a gel. The heating simultaneously inactivates the growth factors and kills the cells in the gel.1 The gel is then mixed with the layer rich in platelets and leukocytes (buffy coat), which can be taken from the same tube, so the material contains cells and growth factors again.2

Estrin et al. state that the heating extends the degradation time from around 2 weeks to 4-6 months.2 The figure is based on the research group's earlier studies and was not measured in the clinical trials below. In one of the trials, the authors could not determine exactly how long the Alb-PRF remained in the sockets.8

In a laboratory study by Lourenço et al., Alb-PRF was a two-phase, cell-rich material that released fewer inflammatory signaling substances than L-PRF (leucocyte- and platelet-rich fibrin) and significantly more of the growth factor platelet-derived growth factor (PDGF). An osteoblast-like cell line showed signs of increased mineralization. The authors emphasize that the findings must be re-examined in animal studies and clinical trials.3

How is extended PRF prepared?

Estrin et al. have described in Dentistry Journal how the research group behind the technique has developed the preparation for socket preservation. The article is a technical description, and the authors themselves call their clinical observations anecdotal. The principle is the same in all variants:2

  • Centrifugation: The blood is centrifuged in tubes to liquid PRF, so that it separates into layers.
  • Heating: The top layer, PPP, is drawn up and heated in a controlled manner, so that the albumin becomes a gel.
  • Mixing: The layer with platelets and leukocytes is mixed with the gel. It can be taken from the same tube as the plasma.

The material can then be used in two ways: shaped into a membrane that is placed over the bone replacement material, or as an injectable mixture that is injected directly over the material and solidifies in the mouth. The injectable variant provides better control over the thickness, e.g. in the front.2 In the group's randomized trial, it took the injectable variant an average of 24 minutes to prepare and place, while the membrane took 38 minutes.4

The procedure varies between the research groups, e.g. in how the plasma is heated and cooled.8, 9 What they have in common is that the temperature and time must be kept precise. The exact protocol depends on the clinic's centrifuge and tubes and is best learned through practical training (see Education).

What is extended PRF used for, and what do the studies show?

The randomized trials of e-PRF and Alb-PRF included here were published in 2025 and 2026. They are smaller trials with 20-55 patients and follow-up from 3 months to 2 years, and the results are not conclusive. In two of the trials, no complications or adverse events were reported, and in a third, all implants survived for the 2 years.5, 7, 8

Socket preservation

e-PRF has been tested as a barrier membrane over bone replacement material after an extraction. In a randomized trial published by Estrin et al. in Dentistry Journal in 2026, 55 patients had the alveolus filled with sticky bone (allograft mixed with PRF) and covered with either a collagen membrane or one of the four e-PRF variants. After 3 months, there was no significant difference in the width and height of the ridge or in the soft tissue thickness. After 2 weeks, early wound healing was significantly better with the two membrane variants than with the collagen membrane, but not with the injectable variant.4

The authors themselves point out that sticky bone holds the bone material together and may hide differences between the membranes, and that the trial therefore can only show whether e-PRF is as good as collagen. There were 11 patients per group, one surgeon and one radiologist, and no agreement was calculated between those who assessed the wound healing.4 We go through socket preservation generally in What is socket preservation?

Implants and bone building

Three randomized trials from the same Egyptian research environment have investigated e-PRF and Alb-PRF in implant placement immediately after extraction. Elnaggar et al. found no significant differences after 12 months between e-PRF and allograft as a filling material around 28 implants in the aesthetic zone of the upper jaw.5 Abdelsameaa et al. found no significant differences after 2 years between e-PRF and a membrane made from the patient's own tooth in guided bone regeneration (GBR) in 40 patients.7 In a preliminary trial with 20 patients with labial bone defects, an Alb-PRF membrane gave small but significant advantages in aesthetic score and marginal bone loss, while a collagen membrane preserved the labial bone thickness significantly better.6

Other applications

Özcan et al. placed Alb-PRF in the pockets after non-surgical periodontal treatment in 23 patients with stage III periodontitis, of whom 21 completed the measurements. After 3 months, the pocket depth and attachment loss were significantly lower than on the control side, but the difference was gone after 6 months.8 In bone cavities after cyst removal, Shokry et al. found no difference in bone formation after 6 months between Alb-PRF and a regular blood clot in 20 patients.9

What should you be aware of?

Pitfalls of extended PRF.

  • The membrane is fragile. Estrin et al. saw in some cases that the membrane was damaged or lost, especially in patients who brushed hard or ate solid food. In one case, the membrane was gone after 2 weeks because the patient did not follow the instructions.2 Alsabahi et al. point out that the weaker structure can cause the membrane to collapse in defects that require the space to be kept open.6
  • The injectable variant depends on the patient. It solidifies in the mouth and can be disturbed by saliva, chewing, and speaking. The patient is advised not to eat or drink for 2 hours after the procedure.2, 4
  • It takes time. In addition to the blood draw, preparation and placement took an average of 24-38 minutes in the randomized trial, depending on the variant.4

What does extended PRF require in the clinic?

In addition to the regular PRF equipment, the clinic must be able to heat the plasma in a controlled manner at a precise temperature, cool the gel, and shape the membranes. Puredent distributes the equipment used in the protocol from Estrin et al.2 You can read more about liquid PRF in i-PRF: what is liquid PRF?

  • BIO-HEAT setup for heating PRF plasma

    BIO-HEAT setup

    Heats the plasma in a controlled manner for the preparation of Alb-PRF and extended membranes.

    See product →
  • BIO-COOL for cooling albumin gel

    BIO-COOL

    Cools the albumin gel before it is mixed with liquid PRF.

    See product →
  • BIOHEAT Tray for shaping extended PRF membranes

    BIOHEAT Tray

    Tray for shaping extended membranes.

    See product →
  • PRF Horizontal Swing-out Centrifuge BP 200

    PRF Centrifuge BP 200

    Horizontal swing-out centrifuge for the preparation of PRF.

    See product →
  • Vacuum tube for liquid PRF, 10 ml

    Tube for liquid PRF

    10 ml vacuum tube for liquid PRF.

    See product →
See the entire range of PRF equipment →

Education in extended PRF

The preparation of e-PRF has more steps than regular PRF, and the exact protocol for centrifugation, heating, and mixing depends on the clinic's equipment. The membrane must also be handled carefully. Practical training in both blood draw and the individual variants can therefore be relevant before the technique is used clinically.

See upcoming PRF courses and blood draw courses →

Frequently asked questions about extended PRF

Are extended PRF and Alb-PRF the same?

They are based on the same principle: PPP from the tube is heated so that the albumin becomes a gel, which is mixed with the layer with platelets. Alb-PRF is often used in scientific articles, while e-PRF is the working name for one specific technique. The preparation varies between the studies.

How long does an extended PRF membrane last?

Estrin et al. state 4-6 months compared to around 2 weeks for regular PRF, but the figure is not measured in clinical trials.2 The membrane is fragile and can be lost early if the patient brushes hard or eats solid food.2

Can extended PRF be used instead of a collagen membrane?

It has been investigated in two smaller randomized trials. In socket preservation with sticky bone, there was no significant difference in the dimensions of the ridge after 3 months in 55 patients.4 In a preliminary trial with 20 implant patients, Alb-PRF gave less marginal bone loss, while the collagen membrane preserved the labial bone thickness better.6 The choice is made by the treating dentist.

How long does it take to prepare extended PRF?

In a randomized trial, it took an average of 24 minutes to make and place e-PRF as an injectable mixture and 38 minutes as a membrane, because the membrane must solidify in the tray first.4

Does extended PRF require a horizontal centrifuge?

The Farshidfar review states that the protocol for albumin gel requires a horizontal centrifuge.1 Two of the clinical trials used a fixed-angle centrifuge, however.8, 9 Use the protocol that applies to the clinic's centrifuge and tubes.

Interests. Puredent distributes the heating equipment used in source 2 and 4, and other equipment for PRF, and sells courses and textbooks with Richard Miron. Source 1, 2 and 4 come from the research group that developed e-PRF. Miron is a co-author on all three and, according to the sources' own statement, founded the company Miron Research and Development in Dentistry, which owns the intellectual rights to the preparation of PRF.1, 2, 4 In the randomized trial on socket preservation, the first author was also a surgeon, and one of those who assessed the wound healing teaches PRF.4 The choice of treatment and material in the individual case is made by the treating dentist.

Sources

  1. Farshidfar N, Apaza Alccayhuaman KA, Estrin NE, et al. Advantages of horizontal centrifugation of platelet-rich fibrin in regenerative medicine and dentistry. Periodontology 2000. 2025;99(1):216-267. DOI · freely available
  2. Estrin NE, Espinoza AR, Ahmad P, et al. The Evolution of Extended Platelet-Rich Fibrin Membranes for Socket Grafting: Part One: Technical Development of Protocols. Dentistry Journal. 2025;13(12):604. DOI · freely available
  3. Lourenço ES, Rocha NRS, de Lima Barbosa R, et al. Investigating the Biological Efficacy of Albumin-Enriched Platelet-Rich Fibrin (Alb-PRF): A Study on Cytokine Dynamics and Osteoblast Behavior. International Journal of Molecular Sciences. 2024;25(21):11531. DOI · freely available
  4. Estrin NE, Ahmad P, Tran TB, et al. The Evolution of Extended Platelet-Rich Fibrin Membranes for Socket Grafting: Part Two: A Randomized Clinical Trial Comparing These Membranes with Collagen Membranes. Dentistry Journal. 2026;14(1):45. DOI · freely available
  5. Elnaggar HMMA, El-Gohary N, Yaseen AAM, et al. Extended platelet rich fibrin versus allograft as a space filling material in immediate dental implant placement. BMC Oral Health. 2026;26(1):1130. DOI · freely available
  6. Alsabahi H, Mowafey B, Kandil I, et al. Clinical and radiographic evaluation of autologous albumin-rich platelet-rich fibrin membrane versus synthetic collagen membrane for immediate dental implant placement in the maxillary esthetic zone: a preliminary randomized clinical trial. BMC Oral Health. 2026;26(1):292. DOI · open access
  7. Abdelsameaa SE, Alruwaili AM, El-Gohary N, et al. Dentine-derived barrier membrane versus extended platelet-rich fibrin for guided bone regeneration: a 2-year randomized clinical trial. BMC Oral Health. 2026;26(1):960. DOI · open access
  8. Özcan E, Ulu Emir B, Avcı E, et al. Effects of albumin-platelet-rich fibrin as an adjunct to non-surgical periodontal therapy in patients with periodontitis: a randomized controlled clinical trial. BMC Oral Health. 2026;26(1):1409. DOI · open access
  9. Shokry MMEM, Melek LNF, Amer TA. Three-dimensional volumetric analysis of bone regeneration following jaw cyst enucleation with and without an autologous albumin gel-platelet-rich fibrin mixture (Alb-PRF): a randomized controlled clinical trial. BMC Oral Health. 2025;25(1):693. DOI · open access